Giải pháp tự động hóa công nghiệp
Chính xác, tin cậy, bên bỉ với sản phẩm và công nghệ truyền động tuyến tính đến từ SKF – EWELLIX – Thụy Điển
Liên hệ
• Designed for compact duo LTDR or quadro units LQBR
• Supports easy building up of linear slides
• Sizes from 12 mm to 50 mm
• Shaft clamping and bolt direction from the top
• Precise and safe shaft fixation to the surface
• Material: aluminium
Compact tandem shaft blocks – LEBS | Đai ốc vít me Ball bearing Ewellix được sử dụng rộng rãi trong nhiều ứng dụng khác nhau, yêu cầu độ chính xác cao.
• Designed for compact duo LTDR or quadro units LQBR
• Supports easy building up of linear slides
• Sizes from 12 mm to 50 mm
• Shaft clamping and bolt direction from the top
• Precise and safe shaft fixation to the surface
• Material: aluminium
Sizes from size 8 mm to 50 mm in aluminium material
Shaft clamping and bolt direction from the top
LEAS A variant for moving quadro slide and fixed shaft blocks to surface
LEAS B variant for moving shaft blocks and fixed quadro unit
Thông số kĩ thuật Standard linear ball bearings – LBCF
Sizes from 12 mm to 50 mm
Open design for long strokes together with supported shafts
Possible tilting angle of ±30 minutes of arc (self-aligning)
Available in variants of 2 seals, 2 shields or seal and shield
Available as bearing steel (standard) or stainless steel variant
Sizes from 12 mm to 50 mm
Shaft clamping screw direction from the side
Able to bolt from top or bottom side to the surface
Reference surface for linear alignment
Sizes from 8 mm to 50 mm
Equipped with 4 self-aligning LBCD bearings
Sealed standard and stainless steel variant
Factory pre-lubricated with SKF LGEP 2 grease, ready for use
Thông số kĩ thuật Standard linear ball bearings – LBCR
Closed design
Sizes from 5 mm to 80 mm
Straight raceway design to support high loads
Available in variants of 2 seals, 2 shields or seal and shield
Available as bearing steel (standard) or stainless steel variant
Open design in sizes from 12 mm to 80 mm
Lightweight die-cast aluminium housing
Able to bolt from top or bottom side
With reference side for linear alignment
