Giải pháp tự động hóa công nghiệp
Chính xác, tin cậy, bên bỉ với sản phẩm và công nghệ truyền động tuyến tính đến từ SKF – EWELLIX – Thụy Điển
Liên hệ
– LHCR in closed design
– LHCS in slotted design for adjustable clearance
• Closed and slotted design in sizes from 8 mm to 80 mm
• Lightweight die-cast aluminium housing
• Able to bolt from top or bottom side
• With reference side for linear alignment
• Supplied with grease fitting for lubrication and axial bearing fixation
Standard housings – LHCR & LHCS | Đai ốc vít me Ball bearing Ewellix được sử dụng rộng rãi trong nhiều ứng dụng khác nhau, yêu cầu độ chính xác cao.
– LHCR in closed design
– LHCS in slotted design for adjustable clearance
• Closed and slotted design in sizes from 8 mm to 80 mm
• Lightweight die-cast aluminium housing
• Able to bolt from top or bottom side
• With reference side for linear alignment
• Supplied with grease fitting for lubrication and axial bearing fixation
Sizes from 12 mm to 50 mm
Shaft clamping screw direction from the side
Able to bolt from top or bottom side to the surface
Reference surface for linear alignment
Thông số kĩ thuật Standard tandem units – LTCR LTCD
Closed design in sizes from 12 mm to 50 mm
Aluminium housing with 2 mounted bearings
Available as sealed or shielded variant
Available as bearing steel (standard) or stainless steel variant
Thông số kĩ thuật Standard linear plain bearings – LPAR LPAT
Closed and open design
Sizes from 5 mm to 80 mm in closed design and from 12 mm to 80 mm in open design
Dimensionally interchangeable with LBC linear bearings
Self-lubricating material
Sizes from size 12 mm to 50 mm in aluminium material
Able to bolt from top or bottom side to the surface
LRCB with Ewellix standard shaft hole pattern ESSC6
LRCC machined for customised hole patterns
Thông số kĩ thuật Standard linear ball bearings – LBCD
Closed design, self-aligning
Sizes from 12 mm to 50 mm
Possible tilting angle of ±30 minutes of arc (self-aligning)
Available in variants of 2 seals, 2 shields or seal and shield
Available as bearing steel (standard) or stainless steel variant
Sizes from 8 mm to 50 mm
Equipped with 4 self-aligning LBCD bearings
Sealed standard and stainless steel variant
Factory pre-lubricated with SKF LGEP 2 grease, ready for use
